Multifunctional 1-channel dimming actuator with 1 output to dim or switch lights on/off and 1 input for integration of additional switches and sensors (110-240 V~). Switching and dimming functionality for all approved trailing-edge phase control dimmable lighting;Leading-edge phase control only for inductive load approved. Featuring integrated logic module with comfort and timer functions, power measurement and short circuit detection (1x 300 W @ 230 V~).

Product characteristics

  • Short-circuit protection
  • Temperature cut-out (>75 °C)
  • Feedback for switching status and dimming value.
  • Parametrisable switching on behaviour and dimming behaviour
  • Switching on and switching off delay with switching off warning
  • Mains supply via power cable, no additional cabling required between frogblue modules.
  • Phase cutting or phase section control can be switched via the frogblue app (phase cutting control only permitted for inductive loads)

Intended use

For assembly in device sockets according to DIN 49073. Socket depth minimum 53 mm when installed behind switch insert, individual installation is required at lower depth.

System information

This device is a product of the frogblue system. Detailed technical expertise obtained through frogblue training sessions is a prerequisite. The functionality of the device depends on the software. Detailed information regarding software versions and the respective range of functions can be found on the frogblue website. Technical descriptions, additional detailed instructions as well as notes, information regarding proper disposal can be found in the manual, which is available on the frogblue website. Commissioning and configuration will be executed using the frogblue app.

Safety information

Electrical devices may only be installed and assembled by qualified, skilled electricians. Failure to observe the instructions can cause damage to the device and result in fire and other hazards. Danger caused by electric shock. Device is not suitable for disconnection from power voltage. Even when the device is turned off, the load is not electrically isolated from the mains. Before starting work on the device or replacing light sources, always disconnect the power supply and switch off the circuit breakers. Country-specific regulations must always be observed.

This website uses cookies. By using this website, you consent to the setting of cookies. More info